Description
Compact square sensing for limited mounting space
The XSZ SZ series describes small square photoelectric sensors for detecting the presence of objects in compact equipment. The supplied series information covers diffuse-reflective, retro-reflective and through-beam arrangements. They use different optical layouts and have different listed sensing distances.
Choose a specific model after checking the target, background, working distance, available mounting space and controller input.
Compare the sensing arrangements
The figures below are taken from the supplied series description. They are mode-level references, not selectable distance settings on one sensor. Confirm the actual rating and required optical components for the model being ordered.
| Sensing arrangement | Source-listed distance | Selection check |
|---|---|---|
| Diffuse-reflective | 10–30 cm figures listed; model rating not mapped | Check the actual target surface and background. |
| Retro-reflective | Up to 2 m | Confirm the specified reflector and alignment. |
| Through-beam | Up to 5 m | Allow space and connections for the matched emitter and receiver. |
The diffuse entry is written as “up to 10 cm–30 cm” in the supplied material, without identifying which model reaches which distance. Do not use 30 cm as a universal diffuse rating.
Series-level technical data
These are entries from the supplied SZ series description. They are not a substitute for the datasheet and wiring diagram of the selected model.
Housing and light-source options
| Housing format | Small square or rectangular |
|---|---|
| Housing material options | ABS or PC, depending on model |
| Sensing arrangements | Diffuse-reflective, retro-reflective and through-beam versions described |
| Light-source options | Visible red LED or infrared LED; confirm by model |
Electrical and environmental entries
| Supply range listed | 10–30 VDC; confirm the selected model’s rated range |
|---|---|
| Supply ripple listed | Less than 10% peak-to-peak |
| Output choices described | NPN or PNP open collector; Light-ON/Dark-ON operation described, model mapping required |
| Load-current entry | Maximum 100 mA; verify by model |
| Circuit protections described | Reverse power-polarity and output short-circuit protection; verify by model |
| Operating-temperature entry | −25 to +55 °C; verify by model |
Planning a compact detection point
This housing format can be evaluated for object-presence checks where space around a bracket or machine frame is limited. Its actual fit depends on the selected model’s dimensions and mounting drawing. Detection performance also depends on the sensing arrangement, target and background.
Before selecting an SZ model
- Identify the target, background, available space and required working distance.
- Confirm diffuse, retro-reflective or through-beam operation and the corresponding optical components.
- Check the exact housing dimensions, mounting holes, cable or connector and light source.
- Match the output, Light-ON/Dark-ON behavior, response requirement and wiring to the controller and selected model.
Frequently asked questions
Do all SZ versions use the same light source?
The series information mentions visible red and infrared LED options but does not map them to individual model codes. Confirm the light source of the version being ordered.
Does every SZ version detect to 5 m?
No. The 5 m upper figure is listed for a through-beam arrangement. The diffuse and retro-reflective entries are different, and the selected model’s rated distance must be checked.
Are NPN and PNP selectable on one unit?
The series material lists both output types but does not map them to model codes or say that one unit can switch between them. Order the output type required by the controller.
Which wiring diagram should be used?
Use the current diagram for the exact model, output type and sensing arrangement. Do not assume that every version has the same connections.




