Description
Metal-housed photoelectric detection
CDD-11P for close-range object detection
The XSZ CDD-11P is a photoelectric sensor with a metal housing and DC three-wire PNP output. The supplied product information lists a 10 cm sensing distance and 10–30 VDC operating supply. Normally open (NO) and normally closed (NC) are separate versions, so the required switching logic should be specified when selecting a unit.
It can be evaluated for object-presence or position checks in compact machine areas. Confirm the sensing method, target and mounting geometry for the actual application before relying on the listed distance.
What the 10 cm specification means in use
The 10 cm figure is the distance listed for CDD-11P in the supplied material, not a promise that every object will be detected at that distance. The usable setup depends on the sensor’s exact optical configuration and the target’s size, surface, color and travel path.
For a machine installation, check the smallest or least reflective target at its farthest intended position. Allow for alignment, nearby surfaces and normal movement of the fixture before finalizing the sensor location.
CDD-11P technical specifications
| Model | CDD-11P |
|---|---|
| Sensor type | Photoelectric sensor |
| Listed sensing distance | 10 cm |
| Supply voltage | 10–30 VDC |
| Output | DC three-wire PNP |
| Switching logic | Separate NO and NC versions; select the required version |
| Housing | Metal |
Choosing the NO or NC version
Choose normally open or normally closed switching to match what the machine controller must see in its normal and detected states. These are two CDD-11P versions, not two outputs available from one unit. Confirm the exact order code and wiring diagram for the version supplied.
The PNP output must also match the PLC or controller input circuit. A PNP sensor provides a sourcing output; a compatible sinking input is normally used. Check the controller manual and the exact sensor wiring diagram before connecting power or a load.
Machine applications and installation checks
CDD-11P can be evaluated for ordinary, non-safety object-presence and position feedback where a compact metal-housed sensor and PNP signal are appropriate. Examples include checking that a part reaches a fixture, that a carrier is present at a transfer point or that an item passes a defined detection position.
- Check the actual target at the required distance, including its smallest size, least favorable surface and normal movement.
- Confirm the optical sensing method and whether the installation requires a reflector or a separate emitter before planning mounting space.
- Select the NO or NC version to suit the controller logic, then verify the exact wiring, supply and permissible output load.
- Use the approved dimensional drawing to check clearances and mounting; the supplied material does not establish usable body dimensions.
Frequently asked questions
Does one CDD-11P provide both NO and NC outputs?
No. NO and NC are separate versions. Specify the version needed for the controller’s intended signal logic.
Is 10 cm guaranteed for every target?
No. It is the listed sensing distance. Verify the exact optical configuration and test the real target, position and surroundings at the required working distance.
Can CDD-11P connect to a PLC input?
It has a listed DC three-wire PNP output. Match it to a compatible controller input and verify the exact version’s wiring diagram, load rating and power supply before installation.
What information helps confirm the right configuration?
Provide the target material, size and surface, required working distance, mounting space, controller input type and the required NO or NC logic.






