Description
E3K100-2M photoelectric detection with relay output
The XSZ E3K100-2M is a 24 VDC photoelectric sensor listed with a 2 m sensing distance and a relay output. The supplied product information describes a red ABS housing measuring 69 × 100 × 45 mm for fixed equipment installation.
It can be evaluated where a longer detection span and a relay signal are needed for presence or position feedback. The exact optical arrangement and the conditions behind the 2 m rating must be confirmed for the selected installation; the available material does not identify a reference target or required optical accessory.
Planning the sensing point and relay interface
A 2 m listed distance can allow the sensor to be mounted away from the detected path, but real performance depends on target size and surface, alignment and surrounding structures. Confirm the optical configuration before deciding where the sensor and any required accessory will be mounted.
The relay output is intended to provide a switched signal to a compatible control circuit. Its contact arrangement and electrical rating are not stated in the supplied material, so the contact load, NO/NC logic and wiring must be checked before connecting the controller or other equipment.
E3K100-2M technical information
The values below are listed in the supplied E3K100-2M product material. Consult the exact-model datasheet and connection diagram before final design.
Detection and electrical format
| Model | E3K100-2M |
|---|---|
| Sensor type | Photoelectric sensor; optical configuration to be confirmed |
| Sensing distance | 2 m, as listed; confirm test target and optical setup |
| Supply voltage | 24 VDC |
| Output | Relay; confirm contact form, rating and wiring |
Housing and installation
| Housing material | ABS |
|---|---|
| Housing color | Red |
| Body size | 69 × 100 × 45 mm, as listed |
| Listed weight | 130 g; confirm included accessories and cable |
Applications and installation checks
The model may be assessed for non-safety vehicle presence or position feedback at a wash station, access gate or industrial handling point. These examples depend on the real target path, environmental exposure and control design; this product information does not establish a certified safety function.
Before specifying E3K100-2M
- Confirm sensing mode, required optical accessories and the actual 2 m target conditions.
- Check relay contact voltage/current limits, NO/NC state, wiring and response time against the controller design.
- Verify mounting dimensions, bracket, cable routing and 24 VDC supply tolerance.
- Establish IP, temperature and chemical-resistance requirements for outdoor or wash-area locations.
Frequently asked questions
Does 2 m apply to every target?
The supplied page lists 2 m without a reference target or optical setup. Verify the selected installation with the actual object and confirm whether a reflector or separate sensing component is required.
What does the relay output connect to?
It provides a switched contact for a compatible circuit, but the available information does not give contact ratings or NO/NC wiring. Check the exact connection diagram before choosing the load.
Can it be installed in a car wash?
Car-wash detection is mentioned in the supplied material, but no IP or chemical-resistance rating is provided. Confirm the enclosure, cable sealing and operating conditions before using it in a wet area.
Is it a barrier-gate safety sensor?
No safety certification or protective-function rating is established by the available product information. Any safety-related gate function needs separately specified and validated equipment.







