Description
T-Type slot detection with two optical axes
The XSZ EUSL-U30 T-Type series is a slot photo sensor described for detecting opaque targets as they pass through the sensing gap. Its two optical axes provide separate A/B detection channels for applications that need two position signals from one sensor assembly.
The supplied series data lists a 30 mm gap and an opaque target larger than Ø12 mm. Check the actual target shape, travel path and mounting drawing before choosing a model.
A/B signals for position checks
The source describes independent optical axes and separate channel signals. For an elevator-leveling or other position-detection arrangement, the controller can evaluate the two outputs as the target travels through the sensing region. The sequence and spacing must be checked against the machine’s actual geometry and controller logic.
Red and yellow status indicators are described for the channels. Confirm their exact correspondence and the Light-ON/Dark-ON control-wire setting in the current diagram for the selected model.
Technical specifications
The entries below come from the supplied EUSL-U30 T-Type series material. Confirm them against the current datasheet for the exact NPN or PNP code before wiring or machine design.
Detection and response
| Detection format | T-Type slot photo sensor |
|---|---|
| Gap distance listed | 30 mm; confirm the dimension on the mounting drawing |
| Detectable object listed | Opaque object larger than Ø12 mm |
| Optical axes | Two independent A/B channels |
| Response-time entry | 1 ms maximum, as stated in the source; confirm test conditions |
Power and output
| Supply voltage | 10–30 VDC |
|---|---|
| Supply ripple | 10% maximum, peak-to-peak |
| Control output | Open collector; NPN or PNP according to model |
| Load current | 100 mA maximum |
| Operation described | Light-ON / Dark-ON selection by control wire; verify the wiring diagram |
Construction and ambient-light entry
| Case / lens material | ABS / PC |
|---|---|
| Connection | Pre-wired 2 m cable |
| Channel indicators described | Red and yellow |
| Ambient sunlight entry | 10,000 lx maximum; confirm test conditions |
Choose the NPN or PNP version
The source lists two separate -T model codes. Select the output type that matches the controller input; do not assume a single unit can change between NPN and PNP.
| Model code | Output listed |
|---|---|
| EUSL-U30R3C4-T | NPN open collector |
| EUSL-U30X3C4-T | PNP open collector |
Application and installation checks
For an elevator-leveling or other position-detection point, confirm that the moving opaque target passes through the intended optical paths and produces the A/B signal sequence required by the controller. The actual mechanical clearance and response margin depend on the installation.
Before specifying a T-Type model
- Confirm the target’s opacity, size, travel direction and position through both optical axes.
- Check the 30 mm gap, channel spacing and mounting dimensions against the current drawing.
- Select the NPN or PNP code and verify the exact channel and Light-ON/Dark-ON control-wire connections.
- Check supply, load, 2 m cable routing, ambient light and required response under the actual operating conditions.
Frequently asked questions
Does one sensor provide two output channels?
The supplied series information describes two independent optical axes with separate A/B signals. Verify the exact channel wiring for the selected model.
Can the same unit switch between NPN and PNP?
The source lists separate NPN and PNP model codes. Choose the code required by the controller rather than assuming the output type can be changed on one unit.
What target size is listed?
An opaque object larger than Ø12 mm is listed. Confirm the object’s shape and travel path because the source does not provide the complete test arrangement.
How is Light-ON or Dark-ON selected?
The series description mentions selection by a control wire. Use the current wiring diagram for the exact model before connecting any conductor.




